Processors are skeptical for good reason.
The problem isn’t the trial.
The problem is how purging is evaluated.
Most tests look at cost per kilo.
The Factory Reset Challenge looks at Price Per Purge.
It’s:
The Factory Reset Challenge reframes the decision by proving:
The Factory Reset Challenge is a structured, guided purge trial designed to restore your machine as close as possible to the condition it was in when you first wrote the cheque for it.
Not a partial clean.
Not a surface sweep.
A true reset.
While results vary by process and application, most Factory Reset Challenges deliver:
This is why customers stop asking:
“Is it more expensive?”
And start asking:
“Why didn’t we do this sooner?”
This challenge is ideal if you:
Run injection moulding, blow moulding, or extrusion
Struggle with carbon, black specks, or long changeovers
Waste significant resin during purging
Have tried other purge compounds without success
Want proof before committing
The challenge may not be right if you:
✖ Only compare products on cost per kilo
✖ Don’t care about downtime or scrap
✖ Aren’t open to changing an underperforming process
This is about performance, not shortcuts.
Then you don’t pay.
The challenge is designed to remove risk, not shift it.
Usually one changeover.
No extended trials. No disruption.
No.
The challenge applies to injection, blow moulding, and extrusion — with products selected based on your process.
No.
Aquapurge products are designed to be operator-friendly and supported by technical guidance.
The Factory Reset Challenge isn’t about switching purge brands.
It’s about:
When machines are clean, people perform better.
Complete the form and a team member will reach out and get you set for the Factory Reset Challenge.
